HEAVY METAL SILICON
TECHNICAL SPECIFICATIONS
- Surface drying time 2-3 h
- Solvent dilution percentage 5%
- Spreading rate 13-15 m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and sanded.
Metallic surfaces should be coated with an anticorrosive primer (Anti-Rust Primer, Minio New Type or Metal Primer).
Glossy metallic surfaces (aluminum, galvanized steel etc) should be first coated with Primer for Glossy Surfaces or surfaces Wash Primer.
APPLICATION
Stir well before use. Apply two coats by roller or brush diluted up to 5% with Brush Solvent T 300 or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 2-3 hours and can be recoated after 16-18 hours. Drying time depends on weather conditions (humidity and temperature). Allow at least 30 days before cleaning and washing newly painted surfaces with Heavy Metal Silicon.
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean spray guns.
TECHNICAL SPECIFICATIONS
- Surface drying time 2-3 h
- Solvent dilution percentage 5%
- Spreading rate 13-15 m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and sanded.
Metallic surfaces should be coated with an anticorrosive primer (Anti-Rust Primer, Minio New Type or Metal Primer).
Glossy metallic surfaces (aluminum, galvanized steel etc) should be first coated with Primer for Glossy Surfaces or surfaces Wash Primer.
APPLICATION
Stir well before use. Apply two coats by roller or brush diluted up to 5% with Brush Solvent T 300 or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 2-3 hours and can be recoated after 16-18 hours. Drying time depends on weather conditions (humidity and temperature). Allow at least 30 days before cleaning and washing newly painted surfaces with Heavy Metal Silicon.
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean spray guns.