DELAC
Transparent acrylic stone varnish, suitable for interior and exterior use. It penetrates surface without creating a film and consequently without yellowing or lifting. It enhances the natural colour of the surface and protects the stone from humidity and stain absorption.
Delac is suitable for all stones or pavement plates, natural or artificial (Eleftheroupolis, Karystou, Piliou, etc.), heat resistant bricks, roof tiles, pore stones, decorative bricks, cement, etc.
- Acrylic penetration one component stone varnish
- Enhances the natural beauty of stone and keeps it ‘alive’ forever
- Does not create films
COLOURS
Available transparent.
TECHNICAL SPECIFICATIONS
- Surface drying time 1-2h
- Spreading rate 10-12m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes.
APPLICATION
Stir well before use. Apply one or two coats by roller, brush or airless
spray gun without dilution. Do not apply at temperatures below 5°C,
above 35°C and/or relative humidity above 80%.
It is touch dry after 1-2 hours and can be recoated after 3-4 hours.
Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and
then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean
spray guns.
Transparent acrylic stone varnish, suitable for interior and exterior use. It penetrates surface without creating a film and consequently without yellowing or lifting. It enhances the natural colour of the surface and protects the stone from humidity and stain absorption.
Delac is suitable for all stones or pavement plates, natural or artificial (Eleftheroupolis, Karystou, Piliou, etc.), heat resistant bricks, roof tiles, pore stones, decorative bricks, cement, etc.
- Acrylic penetration one component stone varnish
- Enhances the natural beauty of stone and keeps it ‘alive’ forever
- Does not create films
COLOURS
Available transparent.
TECHNICAL SPECIFICATIONS
- Surface drying time 1-2h
- Spreading rate 10-12m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes.
APPLICATION
Stir well before use. Apply one or two coats by roller, brush or airless
spray gun without dilution. Do not apply at temperatures below 5°C,
above 35°C and/or relative humidity above 80%.
It is touch dry after 1-2 hours and can be recoated after 3-4 hours.
Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and
then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean
spray guns.