DIAXYL PLUS
Protective and decorative polyurethane solvent-based penetration varnish for interior and exterior wooden surfaces. Due to its special formulation prevents effectively the growth of mould and fungi in the film. It penetrates through the wood pores forming a thin film, allowing it at the same time to breathe. Due to its elasticity follows wood’s contraction and protects it from moisture and UV radiation.
- Polyurethane decorative penetration varnish
- Protects from moisture and UV radiation
COLOURS
Available colourless and in 11 ready shades.
TECHNICAL SPECIFICATIONS
- Surface drying time 2-3h
- Spreading rate 12-16m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes. On new wooden surfaces apply preservative Diaxyl colourless or Diaxyl Extra for protection against mould and insects.
APPLICATION
Stir well before use and repeat occasionally during application. Apply one or more coats by brush, roller or spray gun without dilution. Do not apply at temperature below 5oC, above 35oC and / or relative humidity above 80% or when the wood moisture should exceed 18%.
It is touch dry after 2-3 hours and can be recoated after 24 hours. Drying time depends on weather conditions (humidity and temperature). The final colour of the wooden surface depends largely on its physical colour and absorption, as well as the number of Diaxyl Plus coats applied.
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean spray guns.
Protective and decorative polyurethane solvent-based penetration varnish for interior and exterior wooden surfaces. Due to its special formulation prevents effectively the growth of mould and fungi in the film. It penetrates through the wood pores forming a thin film, allowing it at the same time to breathe. Due to its elasticity follows wood’s contraction and protects it from moisture and UV radiation.
- Polyurethane decorative penetration varnish
- Protects from moisture and UV radiation
COLOURS
Available colourless and in 11 ready shades.
TECHNICAL SPECIFICATIONS
- Surface drying time 2-3h
- Spreading rate 12-16m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes. On new wooden surfaces apply preservative Diaxyl colourless or Diaxyl Extra for protection against mould and insects.
APPLICATION
Stir well before use and repeat occasionally during application. Apply one or more coats by brush, roller or spray gun without dilution. Do not apply at temperature below 5oC, above 35oC and / or relative humidity above 80% or when the wood moisture should exceed 18%.
It is touch dry after 2-3 hours and can be recoated after 24 hours. Drying time depends on weather conditions (humidity and temperature). The final colour of the wooden surface depends largely on its physical colour and absorption, as well as the number of Diaxyl Plus coats applied.
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean spray guns.