FLOOR PRIMER WATER BASED
TECHNICAL SPECIFICATIONS
- Surface drying time 1-2h
- Spreading rate 8-10m2/lt
- Water dilution percentage 5%
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be dry, clean, free from dust, waxes, oils and old floors well abraded.
APPLICATION
Stir well before use. Apply two coats by brush or roller diluted up to
5% with water. Do not apply at temperatures below 5oC, above 35oC and/or
relative humidity above 80%.
It is touch-dry after 1-2 hours and can be recoated after 4-6 hours
after sanding. Then we rub lightly with sandpaper and apply two coats of
Water based Floor Varnish. Drying time depends on weather conditions
(humidity and temperature).
Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.
TECHNICAL SPECIFICATIONS
- Surface drying time 1-2h
- Spreading rate 8-10m2/lt
- Water dilution percentage 5%
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be dry, clean, free from dust, waxes, oils and old floors well abraded.
APPLICATION
Stir well before use. Apply two coats by brush or roller diluted up to
5% with water. Do not apply at temperatures below 5oC, above 35oC and/or
relative humidity above 80%.
It is touch-dry after 1-2 hours and can be recoated after 4-6 hours
after sanding. Then we rub lightly with sandpaper and apply two coats of
Water based Floor Varnish. Drying time depends on weather conditions
(humidity and temperature).
Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.