MARTELITE
TECHNICAL SPECIFICATIONS
- Surface drying time 20-30m
- Solvent dilution percentage 5%
- Spreading rate 8-10m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and sanded.
Glossy metallic surfaces (aluminum, galvanized steel etc) should be first coated with Primer for Glossy Surfaces or surfaces Wash Primer.
APPLICATION
Stir well before use. Apply two coats by roller, brush or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 20-30 minutes and can be recoated after 16-20 hours. Drying time depends on weather conditions (humidity and temperature).
Tools must be cleaned immediately after use with Spray Gun Solvent T 350.
TECHNICAL SPECIFICATIONS
- Surface drying time 20-30m
- Solvent dilution percentage 5%
- Spreading rate 8-10m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and sanded.
Glossy metallic surfaces (aluminum, galvanized steel etc) should be first coated with Primer for Glossy Surfaces or surfaces Wash Primer.
APPLICATION
Stir well before use. Apply two coats by roller, brush or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 20-30 minutes and can be recoated after 16-20 hours. Drying time depends on weather conditions (humidity and temperature).
Tools must be cleaned immediately after use with Spray Gun Solvent T 350.