ANTI-RUST PRIMER

TECHNICAL SPECIFICATIONS

• Surface drying time 45-60min
  
• Solvent Dilution percentage 5%
  
• Spreading rate 12-14 m2/lt
  
• Application by brass
• Application by roller
• Application by Spray gun
  

INSTRUCTIONS

SURFACE PREPARATION

Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and abrased.

APPLICATION
Stir well before use. Apply one or two coats by roller or brush diluted up to 5% with Brush Solvent T 300 or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 45-60 minutes and can be recoated after 20-24 hours. When the coating is thoroughly dry, sand with an appropriate abrasive paper to produce a smooth surface, remove the dust and then apply any Vitex’s enamel water based or solvent based paint. Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean spray guns.