GALVANIZE
TECHNICAL SPECIFICATIONS
- Surface drying time 45-60min
- Solvent Dilution percentage 5%
- Spreading rate 7-9 m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and abrased (a good sanding is needed for “fresh” galvanized surfaces).
APPLICATION
Stir well before use. Apply one or two coats by roller, brush or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 45-60 minutes and can be recoated after 9-12 hours. When the coating is thoroughly dry, sand with an appropriate abrasive paper to produce a smooth surface, remove the dust and then apply any Vitex’s enamel water based or solvent based paint. Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, spray guns, etc. with Spray Gun Solvent T 350.
TECHNICAL SPECIFICATIONS
- Surface drying time 45-60min
- Solvent Dilution percentage 5%
- Spreading rate 7-9 m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and abrased (a good sanding is needed for “fresh” galvanized surfaces).
APPLICATION
Stir well before use. Apply one or two coats by roller, brush or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 45-60 minutes and can be recoated after 9-12 hours. When the coating is thoroughly dry, sand with an appropriate abrasive paper to produce a smooth surface, remove the dust and then apply any Vitex’s enamel water based or solvent based paint. Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, spray guns, etc. with Spray Gun Solvent T 350.