DECKING OIL
TECHNICAL SPECIFICATIONS
- Surface drying time 2-3h
- Spreading rate 14-16m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes.
Surfaces should be clean, dry, and free from dust and grease. Remove any old varnish using an abrasive paper before application. Second layer should be applied on hard woods or where the wood is exposed on harsh weather conditions.
APPLICATION
Stir well before use. Apply one coat by brush or piece of cloth without dilution. Wipe excess material after 5 minutes with a dry cloth. Apply a second coat for tough wood or when wood is exposed to adverse weather conditions. Do not apply at temperatures below 5°C, above 35°C and/or relative humidity above 80%.
It is touch dry after 2-3 hours and can be recoated after 2 days. Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent.
TECHNICAL SPECIFICATIONS
- Surface drying time 2-3h
- Spreading rate 14-16m2/lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes.
Surfaces should be clean, dry, and free from dust and grease. Remove any old varnish using an abrasive paper before application. Second layer should be applied on hard woods or where the wood is exposed on harsh weather conditions.
APPLICATION
Stir well before use. Apply one coat by brush or piece of cloth without dilution. Wipe excess material after 5 minutes with a dry cloth. Apply a second coat for tough wood or when wood is exposed to adverse weather conditions. Do not apply at temperatures below 5°C, above 35°C and/or relative humidity above 80%.
It is touch dry after 2-3 hours and can be recoated after 2 days. Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent.