DIAXYL EXTRA SOLVENT-BASED WOOD PRESERVATIVE
Colorless
solvent-based wood preservative for exterior surfaces such as windows,
exterior doors, fences, panelling etc. It has excellent penetration
properties and protects wood effectively against insects such as
woodworm and other beetles, termites etc. and against wood rotting
fungi, blue stain and mould according to European standards EN 113, EN
73, ΕΝ 84, EN 152 and EN 46, EN 118.
• Protects from insects and fungi
• According to European standards EN 113, EN 73, ΕΝ 84, EN 152 and EN 46, EN 118
COLOURS
Available in colourless.
TECHNICAL SPECIFICATIONS
- Surface drying time 1-2h
- Spreading rate 5m2/L
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes.
APPLICATION
Stir well before use. Apply one or more coats by brush or roller
without dilution. Not for use on wood in direct contact with soil or
water.
Do not apply at temperature below 5°C, above 35°C and/or relative
humidity above 80% or when the wood moisture should exceed 18%.
It is touch dry after 1-2 hours and can be recoated after 24
hours. After it completely dries, apply penetration varnish Diaxyl Plus
or final varnish Lussolac or Marelac. Drying time depends on weather
conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent.
Colorless
solvent-based wood preservative for exterior surfaces such as windows,
exterior doors, fences, panelling etc. It has excellent penetration
properties and protects wood effectively against insects such as
woodworm and other beetles, termites etc. and against wood rotting
fungi, blue stain and mould according to European standards EN 113, EN
73, ΕΝ 84, EN 152 and EN 46, EN 118.
• Protects from insects and fungi
• According to European standards EN 113, EN 73, ΕΝ 84, EN 152 and EN 46, EN 118
COLOURS
Available in colourless.
TECHNICAL SPECIFICATIONS
- Surface drying time 1-2h
- Spreading rate 5m2/L
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean, dry, free from grease, rosins or old varnishes.
APPLICATION
Stir well before use. Apply one or more coats by brush or roller
without dilution. Not for use on wood in direct contact with soil or
water.
Do not apply at temperature below 5°C, above 35°C and/or relative
humidity above 80% or when the wood moisture should exceed 18%.
It is touch dry after 1-2 hours and can be recoated after 24
hours. After it completely dries, apply penetration varnish Diaxyl Plus
or final varnish Lussolac or Marelac. Drying time depends on weather
conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent.