HYROOF PRIMER HYBRID PU
Penetrates, waterproofs and stabilizes new or old surfaces with existing waterproofing.
It shows strong adhesion to concrete, asphalt membranes, cement tiles, acrylic, polyurethane paints etc. It is slightly colored for the purpose of easy detection of the primed area. It is environmentally and user friendly due to the very low content of Volatile Organic Compounds (VOC).
• Hybrid PU primer
• Penetrates, waterproofs and stabilizes surfaces
• Slightly colored
COLOURS
Available in semi-transparent.
TECHNICAL SPECIFICATIONS
- Surface drying time 45min
- Water dilution percentage Χωρίς αραίωση
- Spreading rate 14-16m2/lt
- Application by brass
- Appication by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking material. Cracks or joints should first be filled with Elastomeric Putty by Vitex.
APPLICATION
Stir well before use. Apply one coat by roller, emulsion brush or spay gun evenly all over the surface to be sealed. Do not apply at temperatures below 5°C, above 35°C and/or relative humidity above 80%. Avoid application when rain or frost is expected in the next 48 hours.
It is touch-dry after 45 minutes and can be recoated after 2-3 hours with HyRoof Hybrid PU. Drying time depends on weather conditions (humidity and temperature).
Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.
Penetrates, waterproofs and stabilizes new or old surfaces with existing waterproofing.
It shows strong adhesion to concrete, asphalt membranes, cement tiles, acrylic, polyurethane paints etc. It is slightly colored for the purpose of easy detection of the primed area. It is environmentally and user friendly due to the very low content of Volatile Organic Compounds (VOC).
• Hybrid PU primer
• Penetrates, waterproofs and stabilizes surfaces
• Slightly colored
COLOURS
Available in semi-transparent.
TECHNICAL SPECIFICATIONS
- Surface drying time 45min
- Water dilution percentage Χωρίς αραίωση
- Spreading rate 14-16m2/lt
- Application by brass
- Appication by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking material. Cracks or joints should first be filled with Elastomeric Putty by Vitex.
APPLICATION
Stir well before use. Apply one coat by roller, emulsion brush or spay gun evenly all over the surface to be sealed. Do not apply at temperatures below 5°C, above 35°C and/or relative humidity above 80%. Avoid application when rain or frost is expected in the next 48 hours.
It is touch-dry after 45 minutes and can be recoated after 2-3 hours with HyRoof Hybrid PU. Drying time depends on weather conditions (humidity and temperature).
Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.