DUROVIT
Clear, solvent-based acrylic undercoat with high water resistance and vapour permeability. It exhibits strong adhesion and high penetration in porous surfaces such as plaster, concrete, bricks, plaster boards etc. and also surfaces coated with low quality paints or distempers. It is resistant to moisture and provides an ideal undercoat for emulsion, acrylic or masonry paints, relief and waterproofing coatings.
• Waterproofs
• Strong adhesion and high penetration
• Ideal for stabilizing surfaces covered with low quality paints or distempers
COLOURS
Available colourless.
TECHNICAL SPECIFICATIONS
- Surface drying time 60min
- Solvent dilution percentage 100%
- Spreading rate 14-16m2/lt
- Appication by spatula
- Appication by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking paint.
APPLICATION
Stir well before use. Apply one coat by roller, brush or airless spray gun. For walls diluted up to 100% with Brush Solvent T 300 and for roofs up to 30%. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 1 hour and can be recoated after 4-6 hours for coated with Vitex’s emulsion or acrylic paints. Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent.
Clear, solvent-based acrylic undercoat with high water resistance and vapour permeability. It exhibits strong adhesion and high penetration in porous surfaces such as plaster, concrete, bricks, plaster boards etc. and also surfaces coated with low quality paints or distempers. It is resistant to moisture and provides an ideal undercoat for emulsion, acrylic or masonry paints, relief and waterproofing coatings.
• Waterproofs
• Strong adhesion and high penetration
• Ideal for stabilizing surfaces covered with low quality paints or distempers
COLOURS
Available colourless.
TECHNICAL SPECIFICATIONS
- Surface drying time 60min
- Solvent dilution percentage 100%
- Spreading rate 14-16m2/lt
- Appication by spatula
- Appication by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking paint.
APPLICATION
Stir well before use. Apply one coat by roller, brush or airless spray gun. For walls diluted up to 100% with Brush Solvent T 300 and for roofs up to 30%. Do not apply at temperatures below 5oC, above 35oC and/or relative humidity above 80%.
It is touch dry after 1 hour and can be recoated after 4-6 hours for coated with Vitex’s emulsion or acrylic paints. Drying time depends on weather conditions (humidity and temperature).
Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent.