VISTA DISTEMPER PAINT
Distemper with excellent whiteness and hiding power, suitable for indoors, stairwells, warehouses, kitchen and bathroom ceilings. Allows surfaces to “breathe”.
Distemper (ceiling white) water-based paint for interior use, suitable for ceilings of bathrooms and kitchens, staircases, storehouses and generally where washing is not needed. It provides great hiding power, good spreading rate and superior whiteness, while at the same time allows surfaces to “breathe”.
• Great hiding power
• For ceilings of kitchens, staircases, storehouses
COLOURS
Available in white.
TECHNICAL SPECIFICATIONS
- Surface drying time 30-60 min
- Water dilution percentage 10-20%
- Spreading rate 10 – 12 m2/Lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking paint.
APPLICATION
Stir well before use. Apply two coats by roller, brush or airless spray gun diluted up to 10-20% with water. Do not apply at temperature below 5°C, above 35°C and/or relative humidity above 80%.
It is touch-dry after 30-60 minutes and can be recoated after 3-4 hours. Drying time depends on weather conditions (humidity and temperature).
Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.
Distemper with excellent whiteness and hiding power, suitable for indoors, stairwells, warehouses, kitchen and bathroom ceilings. Allows surfaces to “breathe”.
Distemper (ceiling white) water-based paint for interior use, suitable for ceilings of bathrooms and kitchens, staircases, storehouses and generally where washing is not needed. It provides great hiding power, good spreading rate and superior whiteness, while at the same time allows surfaces to “breathe”.
• Great hiding power
• For ceilings of kitchens, staircases, storehouses
COLOURS
Available in white.
TECHNICAL SPECIFICATIONS
- Surface drying time 30-60 min
- Water dilution percentage 10-20%
- Spreading rate 10 – 12 m2/Lt
- Application by brass
- Application by roller
- Application by Spray gun
INSTRUCTIONS
SURFACE PREPARATION
Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking paint.
APPLICATION
Stir well before use. Apply two coats by roller, brush or airless spray gun diluted up to 10-20% with water. Do not apply at temperature below 5°C, above 35°C and/or relative humidity above 80%.
It is touch-dry after 30-60 minutes and can be recoated after 3-4 hours. Drying time depends on weather conditions (humidity and temperature).
Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.